Technical specifications
23
Mains connection
(standard)
The mains voltage can be set to 115VAC or 230VAC.
Please check the voltage wiring on the transformer connector X3 on the main board.
A C4300-/C7300-unit leaving the factory is set to 230VAC or to 115VAC - depending
on the country of destination or depending on the specification in the order-
/production-paper - meaning:
230V = 230VAC / 50Hz
115V = 115VAC / 60Hz
Ask a skilled labor to change the voltage wiring (and the corresponding primary
fuses) if necessary.
INFORMATION!
Changing the mains voltage requires the replacement of the mains fuse
(primary fuse F1) on the main board (PCB).
For 230VAC mains voltage: micro-fuse 5x20mm – 2.5AT
For 115VAC mains voltage: micro-fuse 5x20mm – 5.0AT
Good sensor
(standard)
The M8 good sensor plug „GSC“ on the side connection plate „SIGNALS“ is set by
default to PNP-Sensors. The optional control line (Pin 2) is not connected (open).
Please – only - use original good sensors from Collamat AG or ask a skilled labor
how to connect another product/brand to your labeler.
Future-Bus
(standard)
The 14-pin connector (left and right – near the main connection terminals on the
main board) will be used if an adapter with future bus cable has to be connected.
Always use the connecter on the adapter side (Labeler version right: use left
connector / labeler version left: use right connector on the main board).
Appl
Modular rail
The applicator unit and the modular rail will be delivered pre wired and pre
mounted (see also chapter “Mounting” in this manual).
Conduct flat ribbon cable(s) + PE-wire through the modular rail
Fix modular rail on traction unit housing (4 screws)
Slide applicator unit onto modular rail
Connect flat ribbon cable (applicator cable 10-pin ) to X1 connector
(applicator board)
Connect flat ribbon cable (optional applicator cable 20-pin) to X3 connector
(applicator board) – if available
Connect PE-wire (green/yellow) to PE blade terminal (applicator board)
Fix applicator housing on modular rail (4 screws)
Screw cover to applicator housing (4 screw)