CHOOSE THE CORRECT LOCATION
NOTE:
The pool must be set up on a completely flat and level surface. Please
do not install the pool if the surface is inclined or sloped.
Correct conditions to set up the pool:
• The selected location has to be capable of uniformly supporting the weight for the
entire time the pool is installed; moreover the location must be flat and must be
cleared of all objects and debris including stones and twigs.
• We recommend positioning the pool away from any objects children could use to
climb into the pool.
NOTE:
Position the pool near an adequate drainage system to deal with
overflow or to discharge the pool.
Incorrect conditions to set up the pool:
• On uneven ground the pool may collapse, causing serious personal injury and/or
damage to personal property and will void the warranty and prevent any service
claims.
• Sand should not be used to create a level base; the ground must be dug out if
necessary.
• Directly under overhead power lines or trees. Be sure the location does not contain
underground utility pipes, lines or cables of any kind.
• Do not set up the pool on driveways, decks, platforms, gravel or asphalt surfaces.
The selected location should be firm enough to withstand the pressure of the water;
Mud, sand, soft / loose soil or tar are not suitable.
• Grass or other vegetation under the pool will die and may cause odors and slime to
develop, therefore we recommend removing all grass from the selected pool
location.
• Avoid areas prone to aggressive plant and weed species that may grow through the
ground cloth or liner.
NOTE:
Check with your local city council for by-laws relating to fencing,
barriers, lighting and safety requirements and ensure you comply with all laws.
NOTE:
If have a filter pump, refer to the pump’s manual for instructions.
NOTE:
The ladder must match the pool size and should be used only for
entering and exiting the pool. It is forbidden to exceed the permitted payload of the
ladder. Check regularly if the ladder is properly assembled.
Installation
1. Lay out all parts and check that you have the correct quantities as listed in the
components list. If you are missing any part do not assemble the pool. Contact
Bestway Customers Service for assistance.
2. Spread out the pool and make sure the pool is right side up. Let it sit exposed to
direct sunlight for 1 hour or more so that the pool is more flexible during set up.
3. Place the pool near an adequate drainage system to deal with overflow water and
ensure the pool’s inlet A and outlet B are correctly positioned to allow your filter
pump to connect to a power source.
NOTE
:
Do not use extension power cords to power your pump.
ATTENTION:
Do not drag the pool on the ground, this can damage
the pool.
1in. - 2in.
2-5 cm
5
1
A
A
A
A
A
A
A
A
A
A
A
A
A
A
A
A
A
C
A
A
C
C
C
C
C
C
C
C
C
C
C
C
2
3
D
F
POWER STEEL™ POOL
4
E
B
A
B
C
D
E
F
G
H
I
J
K
L
NO.
Qty
26
26
26
54
26
54
1
1
2
1
1
1
#B90387 26ft. x 52in. (7.93m x 1.32m)
Part #
P61684
P61352
P61764
P61759
P61760
P61755
90387ASS18
P6H1420
P6H1418
P6H1158
P6(H1)510
P6H1317
7
S-S-005766