9
10
Surface Preparation
Before starting any cleaning task, it is important to inspect the area for objects that
could create a hazard. Remove any objects from the work area that could be tripped
over, such as toys or outdoor furniture. Ensure that all doors and windows are closed
tightly.
When connected directly to garden hose
Only draw water through the unit. For use with cold water supply only. Water hose
must be at least a 1/2” (13 mm) in diameter. Flow rate of water supply must not fall
below 2 US GPM (gallons per minute) [7.6 LPM (litres per minute)] Flow rate can
be determined by running the water for one minute into an empty 5-gallon (19 L)
container. The water supply temperature must not exceed 104°F (40°C).
CAUTION
• Never use the pressure washer to draw in water contaminated with solvents
(e.g. paint thinners, gasoline, oil, etc.).
• Dirt in the water inlet will damage the unit. To avoid this risk, we recommend checking
the water filter (located inside the water inlet. To clean it out, see Maintenance section).
• Always prevent debris from being drawn into the unit by using a clean water source
and an additional accessory water filter if required.
• To prolong the life of the unit, rest the unit for 5 minutes after every
30 minutes of use.
ASSEMBLY AND OPERATING INSTRUCTIONS
ASSEMBLY AND OPERATING INSTRUCTIONS
1
2
Attach high pressure hose to the
machine’s water outlet (hand tighten
only)
Attach high-pressure hose to the gun
assembly (hand tighten only)
Insert adjustable wand to the gun and
twist ¼ turn to lock in position.
Attach the inlet adapter to the
machine’s water inlet. Hand tighten
only. Some models come with inlet
adaptor pre-assembled. Check your
unit.
3
4
