9
Note: Units above 1800 watts (i.e. EH-200-6-L and EH-200-6-L-115) are
classified as permanently connected equipment and will need to be
hardwired by a competent electrician. Guidance notes as follows;
An external switch/circuit breaker and overcurrent protection device must
be fitted inline with hardwired equipment. The switch/circuit breaker
must be positioned near to the unit and marked clearly as the
disconnecting device.
EH-200-6-L (230V):
Mains cable is supplied with this model. Free end to be hard
wired into a suitable 16Amp rated socket, or isolator unit. (continued)
EH-200-6-L-115 (115V):
There are no internal fuses on this model. Suitable
fuses must be fitted in the building supply / distribution point as part of the
installation. Remove the 4 screws holding the terminal mounting plate on the
rear of the unit. Feed mains cable (not supplied) through cable gland and
connect to Ground, Neutral and Live connection points on the 3 way
mains terminal block. Tighten the cable gland in the required position and
replace and secure the terminal mounting plate. Hard wire the free end into a
fused isolation unit and fit 35Amp fuses.
Observation:
the surface of the heating element of a mantle cartridge will upon
receipt look slightly discoloured. This discolouration is normal and occurs at the
factory during test when the mantle is first heated up.
6.
ENVIRONMENTAL PROTECTION
6.1.
Maximum consideration has to be given to environmental issues within the design and
manufacturing process without compromising end product performance and value.
6.2.
Packaging materials have been selected such that they may be sorted for
recycling.
6.3.
At the end of your product and accessories life, it must
not be
discarded as
domestic waste. Ref: EU Directive 2002/96/EC on Waste Electrical and Electronic
Equipment Directive (WEEE). Please contact your distributor / supplier for further
information. For end users outside of the EU consult applicable regulations.
6.4.
This product should only be dismantled for recycling by an authorised recycling
company.
Th
is product and accessories must be accompanied by a completed
Decontamination Certificate prior to any Disposal. Copies of the Certificate are
available from Distributor/Manufacturer.
