11
The mixer is now ready to be attached to a mixer stand (supplied with system) or to a tank clamp.
Recommended stands, tank clamps, and a double (rod) clamp are available through your dealer.
Part numbers are listed in the ACCESSORIES section.
Installation Using a Mixer Stand
1. Set up mixer stand in accordance with the manufacturer’s instructions.
2. Attach a double (rod) clamp to the vertical rod on the mixer stand and tighten clamp screw.
3. Slide rod of adjustable tilt mounting bracket into clamp and secure with clamp screw.
4. Place mixer stand legs around vessel. Tilt angle is adjustable from 0 to 30 degrees.
5. Position the height of the mixer motor by moving the clamp up or down on the mixer stand.
Once installed, the impeller can also be adjusted to the desired height.
Mixer Motor
Keyless Chuck
Shaft
Propeller
Clamp
Mixer Stand
Controller
Pivot Mount
Figure 6: Typical Mixer Setup using a Mixer Stand and Pivot Mount
Note:
The controller can be placed on any flat surface within 6 ft (183 cm) of the mixer motor or can
be mounted on a pivot mount (not supplied). Refer to the ACCESSORIES section for part numbers.
To attach the pivot mount, proceed to the section below. If controller is placed elsewhere proceed
as follows:
6. Connect the 6 ft (183 cm) cable between the mixer motor and the controller rear panel.
7. Check that the controller is not powered. Ensure that the rear panel POWER switch is in the
OFF position.
8.
Connect the 6 ft (183 cm) line cord from the controller to the appropriate 3-wire, grounded
power source.
Summary of Contents for 55008-02
