EPS XP
- 19 -
eps xp_EN - 09/10 - ed. 2
Shower
By pressing the Shower push-button you allow water inlet through the nozzle
located on machine front.
Water inlet stops by pressing again the Shower push-button or STOP.
There is also an automatic water stop after 1 minute inlet.
Cooling
In cooling mode
- Compressor
- Solenoid valve (EVF)
- Beater (high speed = clowise rotation)
will be activated
In cooling, too, the beater always runs together with the Compressor. After
selecting the Cooling push-butrton, the display will show
Set +04°C Mix +14°C
When the set value is reached, Compressor, solenoid valve and Beater will
stop. The Beater will thence start every 30' and runs 15" everytime the
Compressor starts to cool the mix till the temperature set is reached.
The mix is thus controlled by thermostat for indefinite time.
In this case, low beating is activated, unless it is modified as described
below.
Beating modes can be changed by pressing the Beating push-button and, as
by heating, the result will be as follows:
- Beating led fixed: high speed with clockwise rotation
- Beating led blinking: low speed with anticlockwise rotation
In this step the temperature TGV will be controlled for anti-icing.
Beating
By pressing the Beating push-button, the display will show:
TIMER 30:00
Mix +05°C
Beating (high speed = clockwise) will be activated.
The display will show on top the time of 30 minutes, after which the machine
will set at STOP, whereas, down, it will show the mix temperature.
By pressing the beating push-button you can modify Beating mode as follows:
- High speed (clockwise rotation), Beating led fixed
- Low speed (anticlockwise rotation), Beating led blinking
Water tap
By pressing this push-button you activate mix spigot washing. Water inlet
lasts 3 seconds.
When time is over, spigot wash stops automatically and relevant led will
switch off.