6X-1090K
48
Show Temperature/Pressure
(Applies to 3960
HD
/3960
SD
/3920
HD
/3920
SD
/3930
HD
/8800
HD
/5970
SD
/3120
HD
)
Allows display of the existing status of temperature and pressure inside the camera in the left corner of the
video display area. This is intended as a maintenance aid, and allows remote monitoring of the nitrogen
charge pressure of the camera barrel.
NOTE
: For temperature and pressure labels to be displayed, Temperature/Pressure element must be en-
abled in the OSD Configuration Menu.
• Click the Configuration button from the camera configuration/control menu. The Configuration
window will appear.
•
Click the OSD button.
•
Choose the Temperature/Pressure element from pull-down menu.
• Save or Apply configuration. Close the configuration window.
•
Click the Auxiliary button from the control menu on the left side.
•
Click the Show Temperature/Pressure button. Close the window.
Pressure/Temperature will be displayed for several seconds in the top left corner of the image. It will turn
off automatically.
Compass Display (Applies to 3960
HD
/3960
SD
/3920
HD
/3920
SD
/5970
SD
/3120
HD
)
NOTE
: For a compass label to be displayed, Az Elev Zoom element must be enabled in the OSD Configura
-
tion Menu for standard font or Compass element for large font.
Compass display allows users to display compass directions on the video e.g. N, NE, E, SE etc.
•
Compass readings are based on the Azimuth position.
• Azimuth position set as North is the user-defined pan position specified to be the zero degree
point.
•
Azimuth position set as North is normally set to true north. Compass display can be enabled or
disabled by the user.
Compass display can be enabled to identify 8 or 16 compass points:
•
8 compass points: North, South, East, West, Northwest, Northeast, Southwest, and Southeast.
Directions are displayed by one or two letters: N,E,W,S,NE,NW,SE,SW
•
16 compass points: North, South, East, West, Northeast, Northwest, Southeast, Southwest, North
Northeast, East Northeast, North Northwest, West Northwest, South Southeast, East Southeast,
South Southwest, West Southwest. Directions are displayed by one, two or three letters: N, E, W,
S, NE, NW, SE, SW, NNE, ENE, NNW, WNW, SSE, ESE, SSW, WSW.
Below are steps for programming a compass display:
• Click the Configuration button from the camera configuration/
control menu. The Configuration window will appear.
•
Click the OSD button.
•
Choose the Az Elev Zoom element from the pull-down menu
(standard font) or Compass element (large font).
• Save or Apply configuration. Close the configuration window.
• Click the Auxiliary button from the camera configuration/control
menu. The Compass Display menu will appear.
•
Pan the camera to point due North.
•
Click the Set North button to set the current pan angle to 0° (North).
•
Check the Enable OSD box to display the compass point abbre-
viations on the video.
•
Check the Use Timeout box to display compass points for approxi-
mately five seconds after activation.
•
Click the 8 Zones button to identify eight compass points.
•
Click the 16 Zones button to identify 16 compass points.
•
Click the Clear North button to reset the pan angle to defaults.