Cognex Mitsubishi Electric MELSENSOR CF26 Series, User Manual

Page: 39 / 64

6 SYSTEM CONSTRUCTION
6.1 Installation Environment
37
6
6
SYSTEM CONSTRUCTION
This chapter shows how to install optional items to a code reader CF26.
6.1
Installation Environment
Before installing a code reader CF26, check that the installation environment complies with the precautions for use and
general specifications.
 2 PRECAUTIONS FOR USE

Page 15 General Specifications
6.2
Angle Change of a Code Reader CF26
This section shows the precautions and procedure for changing an angle of a code reader CF26 from straight to a right angle
configuration.
Precautions
• Before touching a code reader CF26, be sure to touch an electric conductor such as grounded metal to discharge the static
electricity from your body. Otherwise, damage or faulty operation of the code reader CF26 may occur.
• Be sure to install an I/O connector module to the main module without leaving any space between them. If not installed
properly, dust or water-proof performance may not be obtained.
• Switching the code reader configuration to a straight or right angle should be limited up to 10 times. Exceeding the limit may
cause malfunction.
• Disconnect the code reader CF26 from power before changing the angle.
Operating procedure
1.
Remove the screw covers and unscrew the cap nuts and washers with a T10 torx driver.
2.
Detach the main module and the I/O connector module by pulling them apart.