Cognex 821-0016-1R, Manual

Page: 6 / 94

l
To reduce the risk of damage or malfunction due to over-voltage, line noise,
electrostatic discharge (ESD), power surges, or other irregularities in the
power supply, route all cables and wires away from high-voltage power
sources.
l
The I/O module does not contain user-serviceable parts. Do not make any
electrical or mechanical modifications. Unauthorized modifications may void
your warranty.
l
Changes or modifications not expressly approved by the party responsible
for regulatory compliance could void the user’s authority to operate the
equipment.
l
The maximum torque that can be applied to the terminal block connectors is
0.1921 Nm (1.7 in-lb). Applying torque above this limit can damage the
connectors.
l
Access to the encoder inputs on the In-Sight 5604 Line Scan are not
supported by the I/O module.
l
HS COMMON is not used for high-speed outputs with In-Sight 5000 series
vision systems. The return must use 24V Common.
l
When connecting the In-Sight 7000 series vision system to the
CIO-MICRO or CIO-MICRO-CC I/O module, the I/O module's I/O port
(DB15) is not supported. Do not connect anything to this port.
l
When connecting the In-Sight 7000 series vision system to the
CIO-MICRO or CIO-MICRO-CC I/O module, the I/O module's ,
TRIGGER-, HS OUT 0, HS OUT 1 and HS COMMON terminals are not
supported. Do not connect wire leads from remote devices to these
terminals.
l
Service loops should be included with all cable connections.
4