26
3.2.2.3.- Deactivates troubles
When we detect one of the last troubles and after introducing the level 2 access code pressing the key
ENTER, we will deactivate those troubles. If those troubles were faults we should make sure that they are
corrected; if they aren’t they will appear again in the display.
3.2.2.4.- Setting up zones
To set up a zone means to activate again that zone.
A disabled zone may be done because of: the annulations of the zone for the user, for an alarm, for a relay ON, for
a fault.
We can set up a zone with two different procedures:
Once we have seen the trouble or the fault, we press ENTER.
By the menu 1.SERVICE:
3.2.2.5.- Disable zones
Route : MENU(****)/2.-DISABLE
To disable a zone means to deactivate that zone.
One of the applications of this option is to disable the zone where a fault has been detected.
The zone can be disabled in 2.Disable:
3.2.2.6.- Activate / Deactivate relays
All the relays installed in the control panel can be programmed as: siren, manoeuvre, extinction and
evacuation.
The relays can be activated by menu 3.Activate
•
Activate General Siren
Route : MENU(****)/3.-ACTIVATE/1.- GENERAL SIREN
Activate all relay configured as siren
OFF No activated
ON Activated
SERVICE
No.Zone: 000
SERVICE
Zone on Service
MENU
1.SERVICE
ENTER
+
=
ENTER
+
=
Introducir el nº de zona
DISABLE
No.Zone: 000
MENU
2.DISABLE
ENTER
+
=
Introduction zone nº
1.SIR GEN. OFF
MENU
3.ACTIVATE
ENTER
+
=
ACTIVATE
