11.5. Error messages using DR1
The two leds on the dip-switch panel indicate the functionality of the
Strip Lite Led RGB
.
Whilst every possible precaution has been taken to ensure the trouble-free operation of your
Strip Lite Led RGB
, the following peri-
odic maintenance is highly recommended. We recommend that the voltage to the unit be removed prior to any maintenance proce-
dure taking place.
13.1. Fuse replacement
Use a multimeter to check the fuse, replacing any faulty or damaged fuses with ones of equal value, dimensions and characteristics.
The following diagram indicates the positioning and characteristics of the protection fuse in the fixture.
Fuse A:
3A F 250V
ATTENTION!!
Always remove mains power prior to opening up the fixture!
13. Maintenance
Led
Function
Led on
Led off
Led flashing
Green
Power
Present
Absent
Undefined
Yellow
DMX state
DMX poorly
connected
No DMX signal
DMX OK
12. Switch panel signal
MESSAGE CODE
DESCRIPTION
DTER
DATA Error
The initial configuration settings are fautly or have been loaded incorrectly. The projector has loaded its default
configuration. Turn the projector off and on again and if the error persists the EEPROM is either defective or
absent; refer to your
Coemar
service centre for a replacement component.
ADER
DMX ADDRESS Error
The projector is not receiving all the DMX channels necessary for its operation. Check the DMX address and the
control console operation. Note that some controllers may not generate all 512 channels of signal.
MAER
MASTER MODE Error
This message indicates that the user has attempted to set the unit to MASTER mode whilst DMX signal is still
being received. Detach any DMX control signal or remove MASTER mode settings.
22
English
