5.1. Operating voltage and frequency
The fixture may operate at voltages ranging from 90 to 250V AC at a frequency of 50 or 60 Hz.
It is not necessary to effect any setup procedures, Strip Lite Led RGB
will automatically adjust its operation to suit any
frequency or voltage within this range.
5.2. Mains connection
Mains cable characteristics
The mains cable provided is thermally resistant, complying to the most recent international standards. It meets or exceeds VDE and IEC
norms, IEC 331,IEC 332 3C,CEI 20 35.
NB: In case of cable replacement, similar cable with comparable thermal resistant qualities must be used exclusively (cable 3x1.5 ø external
10 mm, rated 300/500V, tested to 2KV, operating temperature -40° +180°,
Coemar
cod. CV5309).
Connection to mains power
Strip Lite Led RGB
is equipped with two power connectors, one as input and one as output, which can be used to connect more fix-
tures in series.
The maximum current absorbed from
Strip Lite Led RGB
is indicated in the chart below:
•230/240V
0,5 amps constant current in normal operation.
•100/115V
1,1 amps constant current in normal operation.
The maximum working current of the connectors is
16A
.
The maximum absorption Imax is given from the sum of the absorptions of all the
Strip Lite Led RGB
connected in series.
Example:
For a series of 5
Strip Lite Led RGB
connected at 100V,
Imax = 5 x 1,1 = 5,5A
In the following figure you can see an example of series connection:
ATTENTION!!
• The use of a thermal/magnetic circuit breaker is recommended. Strict adherence to regulatory norms is strongly
recommended.
• Strip Lite Led RGB should not be powered through a Dimmer as this may damage the internal switching powersupply.
• Prior to connecting the device to mains power, ensure that the mains characteristics are within the recommended
range for use with the Strip Lite Led RGB.
• A good earth connection is essential for the correcdt operation of the Strip Lite Led RGB. Never install the unit unless
the yellow/gree earth cable is securely connected.
• All cabling and connections should be carried out by suitably qualified personnel.
Imax=16A
ground
neutral
live
brown
blue
yellow/green
main
ATTENTION!!
The absorption of the series of Strip Lite Led RGB (Imax) can never be more than 16A.
5. Powering up
11
English
