English
6
Thank you for having purchased a Coemar product. You have assured yourself of a fixture of the highest quality, both in the
componentry and in the technology used. We renew our invitation to you to complete the service information form on the previous
page. This will assist in providing prompt and accurate advice from your Coemar service centre, which you can thoroughly trust and
to which you can submit any requests for service or information. Following the instructions and procedures outlined in this manual
will ensure the maximum efficiency of this product for years to come.
1.Packaging and transportation
1.1 Packaging
Open the packaging and make sure that no part of the equipment has suffered any damage during the transportation. In case of
damage to the fixture, contact your currier and your supplier immediately by telephone, fax or email, and inform them you will
formally notify them in writing through registered letter.
Packing List
Make sure the packaging contains:
1
Reflection LEDko P
2 This instruction manual.
3-main power plugs
1.2 Trasportation
Reflection LEDko P
must be transported exclusively in its original packaging or in an appropriate flight case.
2. General information
2.1 Important safety information.
Fire prevention:
1.
Never locate the fixture on any flammable surface.
2.
Minimum distance from flammable materials: 0,5m.
3.
Minimum distance from the closet illuminable surface: 0,5m.
4.
Connect the projector to mains power protected by a thermal magnetic circuit breaker.
Preventing from electric shock.
1.
Presence of high voltage inside of the fixture. Insulate the projector from mains supply before opening or performing any function
which involves touching the inside of the fixture, including lamp replacement..
2.
For the connection to the mains, adhere strictly to the guidelines outlined in this manual.
3.
The level of technology of
Reflection LEDko P
requires the use of specialised personnel for all service applications; refer all
work to your authorised
Coemar
service centre.
4.
A good earth connection is essential for the proper functioning of the projector. Never connect the fixture if there is no earth
connection.
5.
Mains cables must not come into contact with other cables.
6.
Do not operate the projector with wet hands or in an area where water is present.
7.
The fixture must never be located in an exposed position, or in areas of extreme humidity.
Safety.
1.
The projector must always be installed with bolts, clamps, or other fixing devices which are suitably rated to support the weight of
the projector.
2.
Always use a secondary safety fixing device with chain or steel wire of a suitable rating to sustain the weight of the unit in case of
failure of the principal fixing point.
3.
The external surfaces of the unit, at various points, may reach 60°C. Never handle the unit until at least 10 minutes have elapsed
since the lamp was turned off
4.
Never install the fixture in an enclosed area lacking sufficient air flow; the room temperature must not exceed 35°C.
5.
The projector contains electronic and electrical components which must under no circumstances be in contact with water, oil or
any other liquid. Failure to do so will compromise the proper functioning of the projector.
2.2 Warranty conditions
1. The fixture is guaranteed for a period of 12 months from the date of purchase against manufacturing or materials defects.
2. The warranty does not extend to damage caused by inappropriate usage, use by inexperienced operators or inadequate
maintenance.
3. The warranty is immediately void if the projector has been tampered or opened by unauthorized personnel.
4. The warranty does not extend to fixture replacement.
5. Both the serial number and the model of the projector are required for any advice or service from your authorised service centre.
2.3 EC Norms
The projector meets all fundamental applicable EC requirements.
