15
15
A00 1
7
. Turning on the projector
After having followed the preceding steps described, proceed with the power supply and
turn on the projector connecting it to the mains power.
The software version installed on the internal microprocessors will be shown on the
display, suddenly it will show the current DMX addressing. If the address blinks, it means
that the DMX signal has not been received. Check the connection cable and the mixer
functioning.
7.1
DMX address of the unit
Each projector can use 11, 8, 4, 1 address channels for its complete operation and is
controlled by a DMX 512 signal.
DMX addressing
When powered up initially, each projector will show A001, which indicates DMX address
001; for example, when set at 11 channels a projector thus addressed will respond to
commands of channel 1 to 11 from your DMX 512 controller. A second unit must be
addressed as A012, a third one as A023 and so on. The operation must be carried out on
every
LEDko EXT FullSpectrum
which has an address different from A001.
Altering the DMX address:
1.
Press the + or – button until the display shows the required DMX address. The digits on
the display will blink to indicate that the variation has not been registered.
2.
Press the enter key to confirm your selection. The digits on the display panel will cease
to blink and the projector will now respond to the new address.
Note:
by holding the + or – button down the scrolling will be faster; thus allowing a faster
selection
Warning!
If you alter the DMX address with no DMX signal connected, the digits on the display
panel will continue to flash even after you have pressed ENTER button to confirm the
address.
