safety chains
We recommend the use of a safety chain fitted through the “
B “
slot of the
ISPOT 1200 EB
and to the suspension truss in order
to avoid the fixture accidentally falling. If using an after-market safety chain not manufactured by
coemar
, ensure that it is of suffi-
cient rating to hold the weight of the unit.
protection against liquids
The projector contains electric and electronic components that must not come into contact with water, oil, or any other liquid.
movement
The projector has a maximum movement of 360° in the base and 260° in the yoke;
DO NOT
place any obstructions in the path
of the projector’s movement.
risk of fire
Each fixture produces heat and must be installed in a well-ventilated position. The minimum recommended distance from flamma-
ble material is: 0.5m. Minimum distance from the object being illuminated is: 2m.
forced ventilation
You will note that the projector features several air inlets and cooling fans, located at the rear of the projector and on the base. Under
no circumstances should these be obstructed.
Obstruction of these cooling features may cause the fixture to overheat and may result in serious damage occurring.
ambient temperature
Never install the fixture in an enclosed area lacking sufficient air flow; the ambient temperature should not exceed 35°C.
cabling
The mains cable provided is thermally resistant, complying to the most recent international standards. It meets or exceeds VDE and IEC norms,
IEC 331,IEC 332 3C,CEI 20 35.
NB: In case of cable replacement, similar cable with comparable thermal resistant qualities must be used exclusively (cable 3x1.5 ø exter-
nal 10 mm, rated 300/500V, tested to 2KV, operating temperature -40° +180°,
coemar
cod. CV5309).
Mains connection
ISPOT 1200 EB
can operate at voltages from 208V-230V-240V at 50 or 60Hz (operating voltage and frequency can be selected
as described in section 5 of this manual).
Prior to connecting the unit to your mains supply, ensure that the model in your possession correctly matches the mains supply avail-
able to you. For connection purposes, ensure your plug is of a suitable rating of 7 amps. Locate the mains cable which exits the
base of the unit and connect as shown below:
protection
The use of a thermal magnetic circuit breaker is recommended for each
ISPOT 1200 EB
.
A good earth connection is essential for the correct operation of the fixture. Strict adherence to regulatory norms is strongly recom-
mended.
massa/ground
neutro/neutral
fase/live
marrone - brown
blu - blue
giallo/verde - yellow/green
alimentazione
main
7. Mains connection
B
B
9
Summary of Contents for ISPOT 1200 EB
Page 2: ......
