Coemar ISPOT 1200 EB, Instruction Manual

Page: 23 / 29

A) replacing gobos on gobo wheel 1:
use a tool such as a screwdriver as a lever on the spring on the inside of the gobo wheel (see fig.1), lifting it from its seat (see
fig.2), after which you can remove the gobo.
Place the new gobo into position and reverse the above procedure, ensuring that the spring sits firmly back in its proper place (see fig.3)
Fig.1
Fig.2 Fig.3
B) replacing gobos on gobo wheel 2:
use a screwdriver to loosen the screw
D
as shown in diagram 4, then sliding the lever towards the top (see Fig.5)
Fig.4 Fig.5
On the opposite side, yo will note an opening as shown in figure 7
Fig.6 Fig.7
At this point proceed as per section A ( replacing gobos on gobo wheel 1). Following this, proceed as in section B ( repla-
cing gobos on gobo wheel 2 ), following the procedures shown in Fig.5 and in Fig.4, sliding the lever in the opposite direc-
tion in order to close up the opening and retighening screw
D
as shown in Fig.4
23