5.1. Operating voltage and frequency
The projector may operate at voltages of 208, 230 or 240VAC at a frequency of 50 or 60Hz.
Coemar
presets (barring specific requests) a
voltage of 230V. The preset voltage is indicated on the base of the projector.
iSpot S
will automatically adjust its operation to suit a frequency of 50Hz or 60Hz.
5.2. Altering the operating voltage and frequency
(Reserved for technical personnel only)
If the factory preset operating voltage and frequency do not correspond to those in use in your country of operation, you may alter the
settings as described in the following paragraphs.
Loosen the screws on the cover of the base of the unit, as shown in the diagram below, using an appropriate screwdriver, thereby remov-
ing the cover completely and allowing access to the internal components of the base of the
iSpot S
.
Locate the transformer in the base of the unit.
Select a voltage from amongst 208, 230 or 240V by disconnecting cable n° 5 and moving it to the correct voltage. Refer to the sticker
located on the transformer to ensure the proper terminal is selected for your requriements.
Cable number 8 must not have its position altered under any circumstances
!
When you have made changes, note these on the outside of the
iSpot S
.
Replace and fasten all the housings as per their original positions.
ATTENTION!!
Incorrect selection of operating voltage and frequency will seriously compromise the
functioning of the projector and will immediately void the warranty.
208V
230V
240V
50Hz
60Hz
T10A
Power
T10A
T 3A
factory set
main at:
5. Powering up
7
English
