MBER
:
COMMUNICATION Error
This message indicates that the motherboard within the unit is not communicating properly with the control sour-
ce. Check the connectors located on both boards.
OPER
:
PAN ENCODER Error
This message indicates that there is a problem with the PAN encoders. Check the sensors on the encoder wheel
located near the pan movement motor, as well as the relevant cabling.
OTER
:
TILT ENCODER Error
This message indicates that there is a problem with the TILT encoder locate on the fixture yoke. Check the sensors
on the encoder wheel located near the pan movement motor, as well as the relevant cabling.
EPER
:
EEPROM Error
The EEPROM is either defective or absent; refer to your coemar service centre for a replacement component.
DTER
:
DATA Error
The initial parameter settings are incorrect or corrupt; the projector has reloaded its factory default settings. Turn
the projector off and on again. Should the error reoccur, refer the unit to your authorised coemar service centre to
have the EEPROM check and possibly replaced.
ADER
:
DMX ADDRESS Error
The projector is not receiving all DMX channels needed to operate correctly. Check the DMX address indicated on
the display and the channel numbers being outputted from the controller. Note that not all controllers will output
all 512 channels.
S2ER
:
Control circuit error relating to position sensors controlling the 4 right-hand motors:
(located in the yoke at right when viewed from the rear or the unit)
Sensor is continuously reading the magnet. Check the cabling and the RESET sensors the motors and the integrity
of the connecting belts.
S3ER
:
Control circuit error relating to position sensors controlling the 5 rear motors:
(located in the rear of the body when viewed from the rear of the unit)
Sensor is continuously reading the magnet. Check the cabling and the RESET sensors the motors and the integrity
of the connecting belts.
S4ER
:
Control circuit error relating to position sensors controlling the 5 front motors:
(located in the front of the body when viewed from the rear of the unit)
Sensor is continuously reading the magnet. Check the cabling and the RESET sensors the motors and the integrity
of the connecting belts.
COER
:
COLOUR WHEEL POSITION Error
Check for correct functioning of the motor and the magnetic sensor and the correct positioning with respect to
the sensor and encoder wheel.
CUER
:
CONVERSION FILTER POSITION Error
Check for correct functioning of the motor and the magnetic sensor of the CONVERSION wheel.
G1ER
:
GOBO WHEEL 1 POSITION Error
Check for correct functioning of the motor and the magnetic sensor of GOBO WHEEL 1.
(wheel furthest from lamp).
G2ER
:
GOBO WHEEL 2 POSITION Error
Check for correct functioning of the motor and the magnetic sensor of GOBO WHEEL 2.
(wheel closest to lamp).
R1ER
:
GOBO WHEEL 1 INDEXING Error.
Check for correct functioning of the motor and the magnetic sensor for gobo indexing.
R2ER
:
GOBO WHEEL 2 INDEXING Error.
Check for correct functioning of the motor and the magnetic sensor for gobo indexing.
EFER
:
FROST/PRISM FILTER POSITION Error
Check for correct functioning of the motor and the magnetic sensor of the FROST/FILTER wheel.
ZOER
:
ZOOM LENSE POSITION Error
Check for correct functioning of the motor and the magnetic sensor of the ZOOM lense.
FCER
:
FOCUSING LENSE POSITIONING Error
Check for correct functioning of the motor and the magnetic sensor of the focusing lense.
ER20
÷
ER99
:
SYSTEM Error
Turn the unit off and on again. If the error persists, contact your authorised coemar service centre.
14. Error messages
25
English
