Coemar DR1, Instruction Manual

Page: 9 / 19

Ensure that your projector is listed as compatible with the DR1 and that the correct software version(s) is installed.
To prepare a fixture to operate with the DR1 , you will need to activate the projector’s identifying code, which must be unique in
the particular DMX512 universe.
The method for setting a projector’s identifying code
ID
may vary from model to model, so we recommend that you consult the
manual of the projector in order to familiarise yourself with the procedure.
For your convenience, we will outline two modes of setting a projector’s id so that it will be able to be addressed by the DR1 regard-
less of whether it utilises a digital display or Dip-Switches.
If a projector is fitted with Dip-Switches the following procedure is appropriate:
1. Set the DR1 REMOTE dip-switch to the ON position.
2. Using dip-switches from 1 to 128 set up the ID (diagram eg. ID = 5)
Setting a projector’s ID makes it unique in the installation.
Attention
The highest ID setting accepted by the DR1 is 250; dip-switch 256 therefore has no function.
ON ON
1 2 4 8 16 32 64 128 256
DR1
remote
Nessuna funzione/
No function
AOO1
F U N C
ID
☞
+/-
0
nessun ID
☞
menu
☞
enter
1-250
choice of an
identification code
from 1 to 250
the code is different
for each unit
connected
to
confirm
☞
enter
☞
+/-
☞
enter
Attention
Do not assign the same ID to two projectors. The will cause the internal functions of the projector to not operate.
Attention
If a projector’s id code is set to “0” the projector will not be addressable via the DR1 and so it’s display will not be able to be ope-
rated remotely.
7. Preparing fixtures to operate with the DR1
26
English