9.3. Advanced functions (installer options)
ATTENTION!
Modifying these settings will modify the operation of the
DIGIfactor
club
6x2,5Kw
. Use these functions only
when necessary.
9.3.1. Lamp pre-heating
Causes sufficient voltage to be applied to the lamp load to assist in preventing lamp failure due to large thermal differences
between lamp on and lamp off states.
NOTE: ATTENTION!
You may set individual pre-heat values for each channel or, by pressing the
+
or
-
buttons till
ALL
is displayed, you may address and set all the channels simultaneously
The voltage value selected above is calculated as a percentage of the input voltage, for ease of use.
DIGIfactor
club
6x2,5Kw
will display a value which is an approximation, not an accuracte reading.
To set the level in memory
Press the
enter
button
DIGIfactor
club
6x2,5Kw
sets the dimmer
channel(s) to the set minimum level, regardless of
incoming DMX signal
function display
Press the
+
or
-
buttons until the required level is
achieved.
Pre-heating set at level
0
function display
Press the
enter
button
For example, number
6
function display
Press the
+
or
-
button until the required channel
is selected
To confirm your selection
Press the
enter
button
To display the lamp pre-heat menu
PrEH
function display
Press the
+
or
-
button
To confirm your selection
Press the
enter
button
Function menu displayed
function display
Simultaneously press the
menu
and
enter
but-
tons
DIGIfactor
club
6x2,5Kw
turns on
Power up
DIGIfactor
club
6x2,5Kw
DIGIfactor
club
6x2,5Kw
will display the RMS
output voltage of the selected channel (in volts).
For example,
230
volts.
function display
Press the
enter
button
For example, channel number
12
function display
Press the
+
or
-
button to select the next channel
you wish to display