9. Display panel functions
Attention!
the display panel controls the proper functioning of the dimmer and its various parameters.
Altering the
coemar
factory presents can vary the functioning of the dimmer, causing it to not respond to
DMX 512
con-
trol signal; careful and thorough reading of all the following procedures is therefore recommended prior to altering any
functions.
IMPORTANT NOTES:
these notes are valid for all the functions which follow
1.
Keeping the
+
or i
-
buttons depressed for 8 seconds for rapid scrolling.
2.
You may abort the altering of any function by simply pressing the
menu
button until the display shows the DMX
address
3.
To immediately go to the maximum value, press the
+
button whilst simultaneously pressing the
-
button.
4.
To immediatley go to the minimum value, press the
-
button whilst simultaneously pressing the
+
button.
5.
You may alter single channel settings or press the
+
or
-
buttons until the display shows
ALL
to alter all channels simulta-
neously.
6.
Changes made via the menu buttons are confirmed and recorded when the
enter
button is pressed.
It is always possible to over-write any settings with new ones at any time.
The reset procedure allows all settings to be returned to factory presets, with the exception of the DMX address.
7.
Display panel functions remain active for 10 secondis if no changes are made, after which they will return to the DMX address
display/
The display panel has three menus and main functions, which are:
9.1. Test
9.2. Electical and electronic displays
9.3. Advanced functions (installer options)
9.1. Test
9.1.1. Tests every channel
Allows the testing of every outlet of the
DIGIfactor
club
6x2,5Kw
, without the need for a controller
You may repeat the test on any individual channel, or, alternatively:
Select an output level from 0 to 99 (maximum output);
via the digital display. As the display value increases,
note that the output level of the load does the same.
function display
Press the
+
or
-
button
Output level set to
00
function display
Press the
enter
button
ALL
to test all channels simultaneously
function display
Press the
+
or
-
buttons
For example, test channel 6 (
t 6
)
function display
Press the
+
or
-
buttons to select the required
channel for testing
To confirm your selection of channel
test
, the
first channel for testing is displayed as 1 (
t 01
).
Press the
enter
button
Channel
test
menu
Press the
+
button
electronics display menu
function display
Press the
menu
button
Address
DMX 001
Power up the
DIGIfactor
club
6x2,5Kw