Coemar Concept Design 384, Manual, Page: 11 / 27

11
7
.
Turning the fixture on and DMX functions
7.1
Turning the unit on
After Concept Design 384 has been connected to mains, to the controller and to the LEDs, the unit will turn
on automatically.
The display will turn on showing the actual DMX channel (A001 default setting). If the DMX signal is not con-
nected the address will blink.
7.2
DMX address setting
When turned on the display will show ”A001” it indicates that the actual DMX address is 001; the unit will
answer to channels 1 to 4, 1 to 6, 1 to 32 or 1 to 48. See DMX charts for further information about functions.
Added units in the DMX line must have as address the multiple number of the previous unit, for example: in 4
channels mode, the second unit will have address A005, the third A009 the fourth A013 and so on.
Altering DMX address (only available with DMX signal connected)
1. Press the + or – buttons until the display shows the required DMX address. The characters in the display will
blink to indicate that the selection is not stored in memory yet.
2. Press the Enter button to confirm your selection. The display panel will cease to flash and the fixture will
now respond to the new DMX 512 address.
NB: holding down the + or – buttons will cause the display to alter at an increate speed, allowing a faster selec-
tion to be made.
Warning!
If you alter the DMX with no DMX controller connected, the characters in the display panel will continue
to flash even after you have pressed the ENTER button.