Technical Manual
Page 39
CODEL
OPS.109
Issue : B
Rev. : 1
Date : 23/10/13
Doc. i/d : 0109/6
Ref. : 090028
9. Basic Fault Finding
The electronics require no routine maintenance. They are all solid state and undergo a rigorous factory burn-in
procedure. If there is any doubt about the equipment performance, the signal processor may be interrogated
from the keypad to determine whether or not the equipment is functioning normally.
The typical display modes and the initial variable values shown in Section 7. DDU Operation will act as a guide
to determine correct performance. This can be done at any time without interrupting or disturbing the analogue
output of the equipment.
The analysers that make up the SmartCem system are sophisticated devices and any problems necessitating
internal repair should only be undertaken by fully trained technicians.
In the absence of CODEL trained technicians on site it is strongly recommended that in the event of a fault
CODEL or its local service agent be contacted immediately with the current information contained in the
analyser records.