7
Inserting/Removing Batteries
Only Code’s CRA-B718 batteries are compatible with the CR7018 case. Insert a B718
battery into the cavity; it will click into place.
The fuel gauge LEDs will light up, indicating the battery’s state of charge. If the LEDs do not
light up, fully charge the battery before using.
To verify the battery is properly connected, a lightning bolt will be
located on iPhone’s battery, signifying a charge status and successful
battery installation. To remove the battery, push both battery
compartment latches inward until the battery pops out. Pull the battery
from the cavity.
Charger Assembly and Mounting
The CR7018 chargers are designed to charge the B718 batteries. Customers can purchase
5 or 10-bay chargers. Two 5-bay chargers are mechanically interlinked to create the 10-bay
charger. 5 and 10-bay chargers use the same power supply (CRA-P71), but have different
cables: the 5-bay charger has a single, linear cable where the 10-bay charger requires a