Pulse Before Start (20 AWG) (LIGHT GREEN/BLACK) 500mA Output
Locate the factory perimeter alarm disarm wire from the key cylinder inside the drivers door.
Verification:
This wire registers ground if the key is turned to the unlock position in the driver’s door cylinder.
Connect the LIGHT GREEN/BLACK wire to the factory alarm disarm wire.
Pulse After Start (20AWG) (LIGHT BLUE) 500mA Output
This wire is usually used to re-lock the vehicle’s doors upon remote start if necessary. See section 6 to
determine what type of door lock system the vehicle has.
Pulse After Shutdown (20 AWG) (BLACK/RED) 500mA Output
This wire is usually used to re-lock the vehicle’s doors if they unlock upon remote start shutdown. It can
also be used to pulse a door pin-switch wire to prevent the vehicle’s accessories from remaining on after
remote start shutdown.
Pulse During Crank (20 AWG) (BLACK/YELLOW) 500mA Output
Locate the vehicle’s second starter (crank) wire at the ignition switch. (if equipped)
Verification:
This wire registers voltage only in the start (crank) position of the ignition switch.
Connect the BLACK/YELLOW wire as shown in the diagram below. Use Code Alarm part HDRLY (an SPDT
relay, not included).
4. 4 PIN REMOTE START PULSED OUTPUTS
Fused +12 Volt
Battery Source
30
87
87a
86
85
BLACK/YELLOW Pulse
During Crank Wire
To Vehicle's2nd
Starter Wire
Jump To VIOLET
Starter Output
Wire From The
Control Module
Summary of Contents for CA- 550
Page 30: ......