3. 6 PIN REMOTE START HARNESS
Battery Power 1 (12 AWG) (RED)
Locate the vehicle battery wire(s) at the ignition switch.
Verification:
These wires will register POS voltage in all positions of the ignition switch.
Connect the RED wire to the vehicle’s battery wire.
Note: Remove all fuses until all connections are made
IMPORTANT!
If the vehicle is equipped with more than one battery wire at the ignition switch, connect the RED
wire from the 4- pin harness and the 2nd RED wire to separate vehicle battery wires.
Accessory 1 (Heater/AC) Output (12 AWG) (ORANGE)
Locate the vehicle’s accessory wire at the ignition switch.
Verification:
This wire registers voltage when the key is turned to the ON (or RUN) position, but not the ACC
(Accessory) position. The voltage drops out when the key is turned to the START (or CRANK) position.
Connect the ORANGE wire to the vehicle’s accessory wire.
Accessory 2 (Heater/AC) Output (12 AWG) (ORANGE/WHITE)
Locate the vehicle’s accessory 2 wire at the ignition switch.
Verification:
This wire registers voltage when the key is turned to the ON (or RUN) position, but not the ACC
(Accessory) position. The voltage drops out when the key is turned to the START (or CRANK) position.
Connect the ORANGE/WHITE wire to the vehicle’s accessory 2 wire.
Ignition 2 Output (12AWG) (PINK/WHITE)
Locate the vehicle’s ignition 2 wire at the ignition switch (if equipped).
Verification:
This wire registers voltage when the key is turned to the ON (or RUN) position, but not the ACC
(Accessory) position. The voltage does not drop out when the key is turned to the START (or CRANK)
position.
Connect the PINK/WHITE wire to the vehicle’s ignition 2 wire.
Positive Shutdown, Brake Safety Switch Wire (18 AWG) (BROWN/RED)
Locate the vehicle’s brake light wire at the brake pedal mounted switch.
Verification:
This wire registers positive voltage when the brake pedal is pressed.
Connect the BROWN/RED wire to the vehicle’s brake light wire.
Summary of Contents for CA- 550
Page 30: ......