Installation
NGT Transceiver Getting Started Guide
49
Mounting the handset and speaker connector
(NGT
AR Voice
and
VR
Transceivers only)
To mount the handset and speaker connector:
1
Use cable ties or screws to secure the handset and
speaker connector in a suitable location.
Mounting the RF unit
To mount the RF unit:
1
Secure the mounting cradle to the surface with at least
four screws, one in each corner of the cradle.
1
If the key is locked to the base of the cradle, flip the key
away from the base until it can be rotated (see
), then rotate the key in a
counterclockwise direction.
1
Place the RF unit into the cradle and push it under the
tabs at the rear of the cradle, then hold the clamp against
the front of the RF unit.
1
Rotate the key clockwise, then push the key toward the
base of the cradle to lock the RF unit into position.
WARNING
If you are transferring a fixed station to a mobile
station and you have installed rubber feet to the
bottom of the RF unit, you must remove the
rubber feet before installing it into the mounting
cradle.
NOTE
Ensure there is sufficient space at the rear
of the cradle to clear the RF unit heatsink.
