Getting started
NGT Transceiver Getting Started Guide
15
1
If you are prompted for details about the call, use the
information in the following table to enter them, then
press
CALL
.
Selective
Sending a selective call to a remote transceiver.
Send Position
Sending your GPS position to a remote
transceiver. A GPS receiver must be connected
to and enabled in your transceiver, or a GPS
position must be entered in the My GPS entry
in the Address List.
If this prompt is
displayed...
Do this...
Select network
• select the network in which you want to make the call
My address?
• select or enter the self address from which you want to send
the call
Select chan/mode
In an ALE/CALM network:
• select
<auto>
if you want the transceiver to select the best
channel/mode for the call, starting with the channel on
which the most recent successful link was established, or
• select the channel/mode you want to use to make the call
In a Codan Selcall network:
• select the channel/mode you want to use to make the call
and check that it is clear of voice and data traffic
NOTE
To abort the call before a connection to the
other station is made, press PTT.
Call type
Icon
Used for...
