11
10
After Sales Support
After Sales Support
1300 663 907
1300 663 907
Model Number
HE170351
Model Number
HE170351
Instructions
Instructions
3.
Check the mount is attached securely to your home before attaching the antenna.
4.
Remove the wing nuts on the mounting attachment located on the main body of the antenna.
This will allow you to insert the mounting pole through the U-Bolt as shown.
1.3 Plugging in the Antenna Cable
The Cocoon Outdoor Antenna Kit includes a 12m F-Type Coaxial Cable. This is a common antenna
cable and is suitable for most houses and installation scenarios. Should you require a longer cable,
contact your local electrical/electronic supplier.
1.
Connect the end of the antenna cable with the socket protector to the connection on the
outdoor antenna. Take care not to bend or damage the pin in the centre of the cable.
2.
Screw the connection firmly to the antenna and cover the cable with the socket protector.
This will help protect the connection from the weather.
NOTE:
When the antenna is mounted horizontally the connection should be underneath the antenna for
better protection from weather.
1.4 Running the Antenna to your TV
1.
The coaxial cable connection on the end of the antenna cable is a male PAL connection. This is
a common antenna connector for most TVs and home theatre systems. Should you require an
adaptor to connect to your device, contact your local electrical/electronic supplier.
2.
Once the antenna has been mounted and the antenna cable has been connected to the
antenna, you can connect the cable to your TV or home theatre system.
3.
Run the cable to your TV or home theatre system.
4.
Plug the male connection into the female connector on your TV or home theatre – this is
usually found at the rear of your TV or amplifier.
NOTE:
It is recommended you check the reception using your TV before you mount the antenna
permanently. Ensure the 12m cable will reach your TV from where you mount the antenna.
5.
Tighten the bolts to secure the antenna in place. Ensure you tighten the wing nuts at the same
rate to balance the mounting attachment.
