9
8
After Sales Support
After Sales Support
1300 663 907
1300 663 907
Model Number
HE170351
Model Number
HE170351
Instructions
Instructions
1.1 Connect Antenna Elements
1.
Attach the antenna elements to the main body by inserting each element as indicated in the
diagrams, then securing with the small screws/wing nuts supplied in the pack.
2.
Folllow each step in order to make assembly easier.
3.
Once the antenna elements have all been attached, your antenna is ready for mounting.
1.2 Mounting Antenna
The Cocoon Outdoor Antenna Kit includes everything you need to mount your antenna on your
home or other outdoor location (except a drill). Included with the kit are masonry anchors and timber
screws. Refer to section Installation Tips on page 7 for antenna installation advice. Consult a
professional if you are unsure or unclear on any steps.
1.
Select the location you wish to mount the antenna using the included faceplate
NOTE:
It is recommended you check the reception using your TV before you mount the antenna
permanently. Ensure the 12m cable will reach your TV from where you the mount the antenna.
1.2.1 Timber Mounting
Included with the kit are 4 wood screws.
a.
Hold the faceplate against the timber then mark the area with a pencil to note the
location of the mounting holes.
b.
Drill pilot holes using a timber drill bit (~ 3mm) to assist in mounting.
c.
Place the faceplate against the timber.
d.
Insert the wood screws through the holes in the faceplate, lined up against the pilot
holes you have drilled.
e.
Tighten the timber screws to hold the faceplate securely.
1.2.2 Masonry Mounting
Included with the kit are 4 masonry anchors.
a.
Hold the faceplate against the masonry then mark the area with a pencil to note the
location of the mounting holes.
b.
You will need to drill a hole into the masonry using a masonry drill bit. The hole must
be able to fit in the masonry anchor, but be no wider, to allow the anchor to take hold
inside the hole.
c.
Place the faceplate against the masonry.
d.
Insert the anchors through the holes in the faceplate, into the holes you have drilled.
e.
Use a 10mm socket wrench to tighten the anchors, securing the faceplate.
2.
Insert the mounting pole into the faceplate, then insert screws through
the pivot hole and the variable adjustment slot. Tighten these screws to
securely attach the mounting pole to the mounting plate.
NOTE:
You can mount the mounting pole by attaching the longer or shorter
end to the mounting bracket. Choose the best method of installation for your
antenna scenario.
TIP:
Confirm the correct angle of the mount before tightening the mounting screws.
Loosen the bolts/screws to adjust the angle of installation.
