Cocoon HE150277, Instruction Manual

Page: 9 / 12

9
After Sales Support
1300 663 907
Model Number
HE150277
02/2016
customercare@winplus.com.au
Instructions
Trim Filament
Cut the filament to your desired length and ensure the tips of both
ends are flat. This ensures the filament can be fed through the
Filament Port smoothly.
WARNING: Always trim the ends of ejected filaments prior to next
use. Placing a melted end into the Filament Port can cause the
material to jam inside the pen.
Insert and Load Filament:
Insert one end of the filament into the Filament Port. Press and hold the Forward Button to
begin loading until filament is extruded from the nozzle.
WARNING: Only use Cocoon Filament for the Cocoon Create 3D Pen (PLA/ABS is
recommended). Attempting to feed other materials through the filament port may cause
damage to the 3D Pen internally, and may void your warranty.
Draw:
Hold the Forward Button to extrude and draw. To stop, release the Forward Button. You
can change the speed of the filament extrusion by adjusting the Speed Slider.
Adjusting Extrusion Speed
The Cocoon Create 3D Pen has a stepless Speed Slider. This allows you to adjust the
speed the filament is extruded from the nozzle.
a. Move the Speed Slider forward towards the nozzle to decrease the speed
b. Move the Speed Slider backwards to increase the speed
NOTE: The speed of the extrusion can also be influenced by the heating temperature
pre-set. If the temperature is too hot for the PLA/ABS, filament will extrude quickly from the
nozzle. If the temperature is not hot enough for the PLA/ABS, extrusion will be slow & dull
Standby Mode
The 3D Pen will automatically switch to standby mode if left unused for 5 minutes. If the
Heat Indicator’s green light is off, the pen is in standby mode. Press the Forward Button to
reheat the 3D Pen until the heat indicator LED light turns green.