Cochran COMMANDER, Owner'S Manual

Page: 22 / 44

2 0
WARNING INDICATIONS:
Failure to observe audible
and/or visual warnings and take corrective action may
result in injury or death. In general, if the WARNING
legend is flashing, some other digits should be
flashing to indicate the anomaly.
•
If the diver is ascending faster than the selected
maximum ascent rate, then the top bar of the
ascent bar graph will flash and the “WARNING”
legend will illuminate. The unique high to low
audible sweep alarm will continue to sound once
per second until the situation is corrected.
•
If the diver descends below the user set Depth
Alarm, the Depth digits will flash. A single beep
audible alarm will sound once per second for five
seconds and will repeat every two minutes. The
Depth alarm is not active in the Decompression
Mode to avoid confusion with the “Shallower
Than Ceiling” alarm.
•
If the battery voltage declines to 2.1 volts, the
“BATT” legend will illuminate, at 1.8 volts it will
flash once per second.
•
If the diver has less than two minutes of No-
Decompression Time (NDC) remaining, the
“WARNING” legend will illuminate and flash
along with the Remaining NDC time digits. A
single beep audible alarm will sound once per
second for five seconds and repeat every two
minutes.
•
If the diver enters the Decompression Mode, a
single beep audible alarm will sound once per
second for five seconds.
•
During a Decompression dive, if the Depth is
less than the CEILING, the “WARNING” legend
will illuminate and flash along with the Depth and
Ceiling digits. A unique low to high audible
sweep alarm will continue to sound once every
two seconds until the situation is corrected.
•
If the dive computer determines that either the
Depth or Temperature sensor is malfunctioning.
The “WARNING” legend will illuminate, the
computer will issue a 5-beep two tone audible
alarm once every two minute to alert the diver to
this condition. On the Appropriate Screen the
Maximum Depth will be replaced with “S-d“ or "S-
-" to indicate the low-pressure transducer or “S-t”
for the temperature transducer.
If an audible alarm is being issued, the computer will
not switch to the Alternate display nor will the
TACLITE™ activate.