Stopping The engine
WARNING!
The cutting attachment can continue rotating after the engine is switched off!
1.Cooling the engine by allowing it to idle for two or three minutes.
2.Slide the ignition switch to the "O" or STOP position. See Figure 21
To Wear the Strap
See
Figure 22
Emergency Release
See Figure 23
1.Hook the strap hook to hanger on the outer pipe.
2.Wear the strap so that the hook stays at your right hand side.
3.Adjust the length of the strap so that you can hold and operate
machine will be released from the strap.
In case of emergency strongly pull he white tab at the hook. The
machine will be released from the strap.
CUTTING OPERATION
METAL BLADE USAGE
Always cut by guiding the head from your right to left.
A metal blade cut best up to the point 1/3 from the edge. Use
that area for cutting shrubs. tough and thick weeds. For cutting
young grass, you can use up to 2/3 from the tip of blade.
Adjust the engine speed according to the cutting objects. Cut
the young grass at middle speed. and cut shrubs or tough and
thick weeds at high speed.
☆
☆
☆
(1) For branches and trees
(2) For grass and weeds
(3) Direction of cutting
(4) Direction of rotation
IMPORTANT
Operating at low speed makes it easier for grass, weeds, or
twigs to become caught up in the blades, and also it makes
the shaft and clutch wear down more quickly.
Nylon cord consumes large power. Please note that the engine
speed in operation should be
50% as large as when using metal blade.
Nylon cutter cuts grass with the power of cord rotation . If you try to cut grass for the length of cord at
one time, rotation speed becomes lower due to resistance and you cannot cut well. In case of large
resistc nce. get the nylon cutter away from grass once , make the rotation speed higher, and cut a
small amount of grass at one time.
If you try to cut grass by swinging the brush cutter in the reverse way (from left to right). scraps fly
in the direction away from the body. You can avoid getting your clothes dirty.
rotation
NYLON CUTTER USAGE
☆
☆
☆
25
Summary of Contents for MT250C
Page 1: ......
