Obstacles, which can be cleared away.
B. The area within a perimeter of 15m of the person using the brush cutter should be
considered a hazardous area into which no one should enter while the brush cutter is in
use, and when necessary yellow waning rope, warning signs should be placed around
work area. When work is to be performed simultaneously by
two or more persons, always check the presence and
locations of others so as to maintain a distance each person
sufficient to ensure safety.
C. Make sure that there are no loose screws or bolt, fuel
leaks, ruptures, dents, or any other problems, which might
interfere with safety operation.Be especially careful to check
that there is nothing wrong with the blades or with the joints
by which the blades are attached to the brush cutter.
D. Never use blades that are bent, warped cracked, broken or
damaged in any way.
E. Keep the blade always sharp.
F. Filling the cutting edge, keep the end corner sharp and
round the root of the edge.
G. Check the bolt to fasten the blade and be sure the blade
turn smoothly without abnormal noise.
NOTES ON STARTING THE ENGINE
1. Take a careful look around to make sure that obstacles exist within a perimeter of
15m or less around brush cutter.
2. Place the brush cutter onto the ground in a flat clear area and hold it firmly in place
so as to ensure that neither the blades nor the throttle came
into contact with any obstacles when the engine start up.
3. Place the throttle into the idling position when starting
the engine.
4. After starting the engine. Of the blades continue to rotate
even after throttle has been move fully back fully turn off
the engine and check the throttle wire and other parts.
KICKBACK SAFETY PRECAUTIONS
A dangerous reaction may occur when the spinning blade contact a solid object in the
critical area. It is called kick back, as a result, the operator can lose control of the unit
which can cause serious or total injury.
Avoid kickback; observe the safety precautions below strictly.
1.Before beginning work, clear your working area and remove grass around the
obstacles.
2.When using your brush cutter, do not grip other parts except the handles.
21
Summary of Contents for MT250C
Page 1: ......
