Starting A Cold Engine-Restarting After Refueling
Control Positions (cold engine)
1.Set the throttle trigger to "Fast idle"
as follows (Figure 24):
figure 26
figure 27
figure 25
Engine ignition is controlled by a
twoposition START-STOP switch mounted
on the throttle body, typically labeled "I"
for START and "O" for STOP.
IMPORTANT
●
Depress and hold the throttle
lockout lever.
●
squeeze and hold the throttle
trigger.
●
Depress the throttle lock button.
●
While holding down the throttle
lock button, release the throttle
trigger and throttle lockout lever.
●
Release the throttle lock button.
2.Slide the
ignition
switch to the
"I" (start)
Position. See
Figure 25.
3.Prime the engine by depressing the
carburetor primer bulb four or five
times, See Figure 26. You should be
able to see fuel inside the bulb.
4.Choke the engine by moving the
choke lever up to the "closed"
position. See Figure 27.
Control Positions (warm engine)
1.Set the throttle trigger to "fast idle"
(see Step 1 above).
2.Slide the ignition switch to the "I"
(START)
position.
3.Moving the choke lever down to the
"open" position.
figure 24
10
Summary of Contents for MT250C
Page 1: ......
