23
Mode Functions
22
VibrAlert and Call Alert
•
Your microTALK radio can alert you to incoming signals by
sounding an audible call tone, by vibrating silently or both.
To change call settings:
1.
Press the
Mode
button
until the
Call Setting
icon
flashes on the display.
The current setting (“01”
v ring, “02” vibrate
only or “03” ring only)
is displayed.
2.
Press the
Channel Up
or
Channel Down
button to
change the call setting.
3.
Choose one of the following:
a.
Press the
Mode
button
to enter the new setting
and proceed to other functions.
b.
Press the
Lock/Enter
button to enter the
new setting and return to
Standby
mode.
10 Call Tone Settings
•
You can choose from 10 different call tone settings to transmit
a unique call alert.
To change a call tone setting:
1.
Press the
Mode
button until the
letter “C” and the current call tone number
(01 through 10) is displayed.
2.
Press the
Channel Up
or
Channel Down
button to hear the other call tone settings.
3.
Choose one of the following:
a.
Press the
Mode
button to enter the new
setting and proceed to other functions.
b.
Press the
Lock/Enter
button to enter the
new setting and return to
Standby
mode.
During memory location scan (while receiving an Incoming
transmission), you can choose from the following:
a.
Press and hold the
Talk
button to communicate on that
memory location.
b.
Your radio will remain on that memory location and return to
Standby
mode. Press the
Channel Up
or
Channel Down
button
to resume scanning memory locations.
c.
After 10 seconds of inactivity, unit starts scan again.
If you press the
Talk
button while scanning, but more than
10 seconds after receiving a transmission, you will transmit on
the memory location on which, during scanning, you last received
a transmission.
If you do not press any button within 10 seconds, your radio
will automatically resume scanning memory locations.
During memory location scan (while not receiving a
transmission), you can choose from the following:
a.
Press and hold the
Talk
button to communicate on the
channel/privacy code that was displayed before you entered
mode functions or memory location on which, during
scanning, you last received a transmission.
b.
Press the
Mode
button to proceed to other functions.
c.
Press the
Lock/Enter
button to return to
Standby
mode
on the channel/privacy code that was displayed before you
entered mode functions or the memory location on which,
during scanning, you last received a transmission.
To reduce the number of memory locations being scanned,
you may de-program any unwanted locations. (See page 16
to de-program a memory location.)
Operation
Customer Assistance
Warranty
Introduction
Operation
Mode Button
Channel Button
Vib Ring
VibrAlert Only
Ring Only
Nothing
Comes Close to a Cobra
®
Mode Button
Channel Button
Call Tone Setting
