Customer Assistance
Warranty
Introduction
21
Nothing
Comes Close to a Cobra
®
Operation
20 English
Operation
During memory location scan (while receiving an Incoming
transmission), you can choose from the following:
a.
Press and hold the
Talk
button to communicate on that
memory location.
b.
Your radio will remain on that memory location and return to
Standby
mode. Press the
Channel Up
or
Channel Down
button
to resume scanning memory locations.
c.
After 10 seconds of inactivity, unit starts scan again.
If you press the
Talk
button while scanning, but more than
10 seconds after receiving a transmission, you will transmit on
the memory location on which, during scanning, you last received
a transmission.
If you do not press any button within 10 seconds, your radio
will automatically resume scanning memory locations.
During memory location scan (while not receiving a
transmission), you can choose from the following:
a.
Press and hold the
Talk
button to communicate on the
channel/privacy code that was displayed before you entered
mode functions or memory location on which, during
scanning, you last received a transmission.
b.
Press the
Mode
button to proceed to other functions.
c.
Press the
Lock/Enter
button to return to
Standby
mode
on the channel/privacy code that was displayed before you
entered mode functions or the memory location on which,
during scanning, you last received a transmission.
To reduce the number of memory locations being scanned,
you may de-program any unwanted locations. (See page 15
to de-program a memory location.)
Memory Location Scan
•
Your microTALK
®
radio can automatically scan up to
10 programmed
Memory Locations
.
If there are one or fewer memory locations
programmed in your radio, the scan memory
locations option will not be available. To program
at least two memory locations, see program
memory locations on page 12.
To scan memory locations:
1.
Press the
Mode
button until the
Scan
icon,
Memory
icon and the memory location
number flash on the display.
2.
Press the
Channel Up
or
Channel Down
button to begin scanning memory locations.
The
Scan
icon and the
Memory
icon will
continue to be displayed when memory
location scan is
on
. Your radio will continue
to scan memory locations and stop if an
incoming transmission is detected. Your
radio will remain on that memory location
for 10 seconds.
While setting memory location scan, if you
do not press any buttons for 15 seconds,
your radio will automatically return to
Standby
mode on the channel/privacy code
displayed before you entered mode functions.
Scanning Locations
Mode Button
Channel Buttons
Mode Functions
