![background image](http://html1.mh-extra.com/html/cobra/cx65-2022/cx65-2022_manual_2630607009.webp)
8
Proper tension and adjust if necessary.
Adequate
lubrication
and
lubricate if necessary.
o
Insure that the ignition stator and rotor are clean and dry.
o
Check the frame for cracks in the metal or cracks in the paint that might
indicate that the metal has been stressed beyond it’s safe limits.
Replace or get properly re-welded as necessary.
o
Check the spokes for tightness and adjust if necessary.
o
Check the rims and hubs for signs of stress, like cracks around the rim,
spokes and hub.
Every 2 hours of operation
o
Replace the transmission oil.
o
Check spoke tension
Every 10 hours of operation
o
Replace the fork oil.
o
Have the shock oil replaced by a Certified Cobra Mechanic.
CAUTION:
If you ever need to weld anything on the bike, disconnect the spark plug cap,
unplug the ignition, disconnect the kill switch, scrape the paint bare near the area
to be welded and put the ground clamp as close to the area to be welded as
possible.
Be sure the fuel tank and carburetor have been removed and safely located away
from the welding process.
The frame is a combination of HSLA steel and 4130 Chrome Moly and it is
important to weld it with the proper rod and heat settings set as light as possible.
Cobra recommends replacing the frame with a new one if the old one becomes
damaged. Use ER70S6 filler if welding on the frame.
Replacing Transmission / Clutch Lubricant
Tools needed:
18 oz, of high quality transmission oil, or Cobra clutch milk
8 mm Allen wrench
CAUTION:
General automotive motor oil has frictional modifiers which will cause premature
wear and failure of the clutch.
Procedure:
1. Begin this procedure with a bike that has been ridden more than 5 minutes but
less than 10 minutes. It is desired to have the engine warm enough so that the
oil is ‘runny’ but not so hot that there is risk of being burned by the engine or the
oil.