![background image](http://html1.mh-extra.com/html/cobra/cx50fwe/cx50fwe_manual_2630604009.webp)
9
cases and can damage the stator as it cools off because of lack of airflow
around the stator.
8.
If you ever need to weld anything on the bike, disconnect the spark plug
cap, unplug the ignition, disconnect the kill switch, scrape the paint bare
near the area to be welded and put the ground clamp as close to the area
to be welded as possible.
Be sure the fuel tank and carburetor have been removed and safely located
away from the welding process.
9.
The frame is 4130 Chrome Moly and it is important to weld it with the proper
rod and heat settings set as light as possible. Cobra recommends replacing
the frame with a new one if the old one becomes damaged. Use ER70S6
filler if welding on the frame.
10. If your kick-starter lever does not return properly, first try loosening the six
kick/clutch cover screws ½ turn. Hold the kick lever ½ way down while
retightening the six screws starting for the center and working out
11. Inspect CFD slip torque after the 2
nd
ride and then again after the 6
th
ride.
After this follow the recommended schedule below.
12. Check proper clutch engagement before and after each ride. If the clutch is
engaging properly DO NOT feel the need to take the clutch apart to;
measure the spring stack, clean the stack, replace the springs, etc... Cobra
has worked very hard to make a clutch that is low maintenance and so only
take it apart if it NEEDS to be maintained.
Schedule
Prior to each ride
o
Check the air filter (clean and re-oil as necessary).
o
Insure the smooth operation of the throttle cable (throttle soundly
‘clacks’ shut).
o
Check for frayed strands of the throttle cable inside the throttle housing
and replace if necessary.
o
Check for adequate tire pressures and adjust if necessary.
o
Check all nuts and bolts for proper torque and re-torque if necessary.
o
Spray all moving parts with WD40 or other light oil.
o
Check drive chain for
Proper tension and adjust if necessary.
Adequate
lubrication
and
lubricate if necessary.
o
Insure that the ignition stator and rotor are clean and dry.
o
Check the frame for cracks in the metal or cracks in the paint that
might indicate that the metal has been stressed beyond it’s safe limits.
Replace or get properly rewelded as necessary.
o
Check the rims for signs of stress, like cracks around the rim, spokes
and hub.
o
Equalize the pressure in the forks with atmosphere.
Every 2 hours of operation
o
Replace the transmission oil.
Summary of Contents for CX50FWE
