“
QUICK REFERENCE”
USER MANUAL
4693-4698
2
“QUICK REFERENCE” USER MANUAL 4693-4698
To disable the volumetric protection proceed as follow:
Arm the system pressing the “A” pushbutton of the remote control, pressing another time the “A” pushbutton the volumetric
protection (Ultrasonic sensors) is deactivated, the deactivation is con
fi
rmed by one
fl
ashing of the direction indicators and one beep.
Pressing another time the “A” pushbutton the volumetric protection is re-activated and the external sensors are deactivated,
the deactivation is con
fi
rmed by two
fl
ashing of the direction indicators and two beeps.
Pressing another time the “A” pushbutton, the volumetric protection and the external sensors are deactivated, the deactivation
is con
fi
rmed by three
fl
ashing of the direction indicators and three beeps, or
switch the engine off being sure that the ignition switch has been turned to the OFF position. Within 5 s press the emergency
panel pushbutton and keep it pressed until it will
fl
ash once to con
fi
rm that the volumetric protection only has been disabled. By
keeping the pushbutton pressed the system will con
fi
rm with two
fl
ashes that the additional sensor input only has been disabled,
with three
fl
ashes for both of them disabled. The selected protection will remain disabled until the system will be disarmed. It will
be automatically restored at the next arming.
2.6 - Emergency panel LED -
The LED main scope is to show the system arming and disarming conditions. When the system is
armed the LED gets ON and remains illuminated until the 25 s arming period has elapsed. After that it starts blinking. It goes OFF
as soon as the system is disarmed.
2.7 - Alarms memory -
If the system has gone off
(alarm on) during the arming time it will warn you with
3
fl
ashes of the direction lights and 3 audible signals
(5 audible signals if the arming/disarming audible
signals function has been activated). It also stores in its
memory the reason of the occurred alarm and shows
it on the emergency panel LED. Count the number of
fl
ashes and check the corresponding alarm reason on
the table. By turning the key ON the memory will be
deleted.
2.8 - Emergency disarming -
If the remote control get lost or if it doesn’t work, open the door with the mechanical key and disarm
the system following the emergency procedure described in chapter 4.
2.9 - Direction lights alarm
fl
ashes -
When the system goes off (alarm ON) the siren sounds and the direction lights
fl
ash for 28 s.
3. - PROGRAMMABLE FUNCTIONS
3.1 - Activation and volume adjustment of the audible arming and disarming signaling -
This function allows to activate a
short audible signal to con
fi
rm the system’s arming and disarming.
3.2 - Passive arming -
The system will automatically arm after 30 s the ignition key has been switched off and the driver side door
has been opened and closed, so 30 s after the driver has left the vehicle.
3.3 - Auto re-arming -
The system will automatically re-arm if, after 115 s, it has been disarmed and no one door has been opened
(nobody gets on the vehicle).
3.4 - Auto re-arming with doors locking -
As for auto re-arming, but doors will lock.
3.5 - Passive engine starting inhibition -
The starting inhibition becomes active after 115 s the vehicle has been switched OFF.
The starting inhibition is immediately deactivated if the Driver Card (optional) is detected or when a correct emergency PIN Code
has been digit on the emergency panel. This functionality is totally independent from the other ones.
3.6 - Confort window closing with remote control -
This is a native function of the vehicle, so at
fi
rst check if it is available. If
not you can ask your installer to
fi
t an additional window closing module. By keeping pressed the Cobra remote control pushbutton
“A” you can close the windows from a distance.
Warning:
for safety reasons we recommend to close the windows remaining close to the vehicle.
LED NUMBER
OF FLASHES
ALARM
ROOT CAUSE
1
fl
ash
Door opening detection.
2
fl
ashes
Ultrasonic volumetric detection.
3
fl
ashes
Bonnet opening detection.
4
fl
ashes
Ignition key ON detection.
5
fl
ashes
Boot opening detection.
6
fl
ashes
Door opening detection.
7 ÷ 14
fl
ashes
“Technical alarm” detection.
Contact your installer.
4693-4698 “
QUICK REFERENCE”
USER MANUAL
4693-4698 “QUICK REFERENCE” USER MANUAL
3
3.7 - Anti hi-jacking.
This function helps to prevent the vehicle hi-jack while driving, taking care also to the safety of the driver. If the driver isn’t recognized,
the system will consider him as an unauthorized person to drive the vehicle; it will generate an alert sequence and it will not allow
the engine starting after it has been switched off.
During the normal usage of the vehicle the driver is recognized by the system in two ways:
-
manual (without Driver Card*)
: by entering the
fi
rst two Pin Code digits on the emergency panel.
The driver must be recognized by the system every time the ignition key is switched on or when, with the ignition key on, the driver
opens and closes the driver side door to get off. If the recognition doesn’t happen within 60 s the LED of the system starts to
fl
ash
quickly, reporting the failed recognition for further 30 s. When this time is expired, the system generates an alert sequence also
if the engine is running. The engine cranking inhibition becomes active with the ignition key off, making impossible the engine
running. To exit the anti hi-jack function, enter the four digits of the Pin Code.
-
automatic (with Driver Card*)
: the driver must be recognized by the system when it detects the Driver Card.
If the recognition doesn’t happen within 60 s the LED of the system starts to
fl
ash quickly, reporting the failed recognition for further
30 s. When this time is expired, the system generates an alert sequence also if the engine is running. The engine cranking inhibition
becomes active with the ignition key off, making impossible the engine running. To exit the anti hi-jack function, the system must
recognize the Driver Card. If the Driver Card is switched off, press the push-button of the Driver Card to be recognized.
Warning:
to temporarily deactivate the anti hi-jack function (Driver Card broken or with
fl
at battery), type the four digits of the Pin
Code. The function will become active again by opening and closing the driver’s door when the ignition key is on or by
turning the ignition key ON and OFF.
Note:
the function is as standard disabled in compliance with the European regulation. Its activation voids the CE homologation.
It can be used only in the extra-European countries, if the functionality is not in con
fl
ict with the local rules.
* optional
3.8 - Garage mode -
This function allows to temporarily disable all protection automatic functionalities of the system. It can be
used, as an example, when you need to leave the vehicle at a workshop for maintenance to avoid the automatic activation of any
functionality. When the garage function is active the driver is allowed to turn the ignition key on for 10 times (engine running). After
10 times the system restore all automatic functionalities.
Activation
- Open driver side door.
- Turn the ignition key ON.
- Enter the complete emergency PIN Code (4 digits) on the emergency panel pushbutton.
-
A
fl
ash of the direction lights con
fi
rms the activation.
Deactivation
- Lock then unlock the vehicle with the original remote control.
-
A
fl
ash of the direction lights and an audible signal con
fi
rm the deactivation.
4. - EMERGENCY OVERRIDE WITH PIN CODE
If the remote control get lost or if it doesn’t work, open the door with the mechanical key and disarm the system proceeding as follow:
press the emergency panel pushbutton for a number of times corresponding to the
fi
rst digit of the PIN Code. Each pushbutton
pressure is con
fi
rmed by a quick
fl
ash of the LED. Make a longer pause to let the system understand that you’ve
fi
nished to enter
the
fi
rst digit, a longer
fl
ashing of the LED will con
fi
rm it. Do the same for the remaining digits, as soon as all four digits will be
entered the system will disarm.
SIREN
ON
ALARM
SYSTEM
DISARMED
PIN CODE
OK
Press for a number of
times equal to the figure
in the PIN code
Enter next
PIN CODE
figure
Short
flash
Long
flash
pause
