INSTALLATION MANUAL 4693-4698
18
7. - PROGRAMMABLE FUNCTIONS.
(see the “FUNCTIONS PROGRAMMING TABLES” manual).
8 - NEW REMOTE CONTROLS AND / OR DRIVER CARDS (optionals) SELF LEARNING PROCEDURE.
(see ‘PAGE 2’ of the “FUNCTIONS PROGRAMMING TABLES” manual).
9. - FUNCTIONAL TEST.
During the
fi
rst 25 s after the system has been armed all protection functionalities can be tested without triggering an alarm.
Make the following tests during the 28 s inhibition time with the system armed:
open then close one by one all doors and boot
- Check if the system is con
fi
rming with three audible signal, each door
opening detection.
Check the proper functionality of the volumetric ultrasonic sensor
- Make movements, their detection will be con
fi
rmed
by a LED
fl
ashing.
Open the bonnet then lock the vehicle with the remote control
- After 28 s from arming the system will indicate the
bonnet opening with 3 audible signals.
Try to start the engine
- If the engine cranking wires have been connected the engine will not start.
Check if the PIN emergency Code works properly
- By correctly entering the PIN code the system disarms.
10. -
SELF LEARNING PROCEDURE REQUIRED TO REPLACE THE MAIN UNIT OR THE WIRELESS
SIREN REPLACEMENT.
The siren supplied in the kit is delivered already programmed to the main unit. Should you have the need to replace the
siren or the main unit it is required to perform the self learning procedure as follows:
IMPORTANT
: don’t perform the procedure on two different vehicles parked closed each other. Their sirens could be
memorized in one main unit only.
A. Power the main unit by connecting the 26 ways connector.
B. Connect the main unit blue wire to GND (only when a wireless siren is
fi
tted).
C. Open the bonnet.
D. Connect the siren blue wire to GND (if not already grounded through the additional bonnet
pushbutton).
E. Disconnect the siren 6 ways connector, then plug it again.
F. Within 60 s turn the ignition key ON, an audible signal con
fi
rms that the siren has been stored in the system.
G. Turn the ignition key OFF and disconnect the BLU wires of the main unit and of the siren from GND (if grounded through
the additional pushbutton simply open the bonnet).
Check the system functionality arming the system and triggering the alarm to check the proper sounding of the siren.
