INSTALLATION MANUAL 4693-4698
16
6. - ACTIVE FUNCTIONALITIES.
6.1 - Interior protection with ultrasonic volumetric sensor.
The system protects the vehicle interior with a volumetric ultrasonic sensor. Any attempt to get into the vehicle will be
detected and the alarm will trigger.
6.2 - Perimetric protection with door open warning diagnostic.
The alarm will trigger by opening any door, boot and bonnet. Should you have left any door opened while arming, the system
will signal it by 3
fl
ashes of the direction lights and 3 audible signals (5 audible signals if the arming/disarming audible
signals function has been activated).
6.3 - Cable cutting protection
(only for systems with back-up battery siren).
The alarm will trigger if the system is not power supplied (cutting of cables - battery disconnection) signalling the sabotage.
6.4 - Engine crank inhibition.
As soon as the system is armed the engine cranking is not possible anymore.
6.5 - Arming the system with the volumetric ultrasonic protection disabled.
This function allows to arm the system leaving temporarily disconnected the interior volumetric protection. The protection
must be disabled any time you leave somebody or an animal in the vehicle. If you want to leave any window opened also
disable the protection to avoid false alarms. All other protections remain active.
To disable the volumetric protection proceed as follow:
Arm the system pressing the “A” pushbutton of the remote control, pressing another time the “A” pushbutton the volumetric
protection (Ultrasonic sensors) is deactivated, the deactivation is con
fi
rmed by one
fl
ashing of the direction indicators and
one beep.
Pressing another time the “A” pushbutton the volumetric protection is re-activated and the external sensors are deactivated,
the deactivation is con
fi
rmed by two
fl
ashing of the direction indicators and two beeps.
Pressing another time the “A” pushbutton, the volumetric protection and the external sensors are deactivated, the deactivation
is con
fi
rmed by three
fl
ashing of the direction indicators and three beeps, or
switch the engine off being sure that the ignition switch has been turned to the OFF position. Within 5 s press the emergency
panel pushbutton and keep it pressed until it will
fl
ash once to con
fi
rm only the volumetric protection has been disabled.
By keeping the pushbutton pressed the system will con
fi
rm with two
fl
ashes that only the additional sensor input has been
disabled, with three
fl
ashes for both of them disabled. The selected protection will remain disabled until the system will be
disarmed. It will be automatically restored at the next arming.
6.6 - Emergency panel LED.
The LED main scope is to show the system arming and disarming conditions. When the system is armed the LED gets
ON and remains illuminated until the 25 s arming period has elapsed. After that it starts blinking. It goes OFF as soon as
the system is disarmed.
