![background image](http://html.mh-extra.com/html/cobra/19-ultra-ii/19-ultra-ii_how-to-use-manual_2631053009.webp)
5
Installation (Cont.)
3.
Connect the antenna cable plug to the standard receptacle on the
unit. Most CB antennas are terminated with a type PL-259 plug
which mates with the receptacle marked ÒANT.Ó
4.
Connect the red lead of DC power cord to +13.8VDC. In automo-
bile installations, +13.8VDC is usually obtained from the accessory
contact in the fuse box. This prevents the set being left on acciden-
tally and also permits operating the unit without the vehicleÕs
engine running.
Before installing the CB radio, visually check the vehicle battery
connections to determine which battery terminal, positive or neg-
ative (positive is the larger of the two) is grounded to the engine
block (or chassis).
5.
Connect the black lead to the negative side of the automobile. This
is usually the chassis of the car. Any convenient location with good
electrical contact (remove paint) may be used.
6.
Mount the microphone bracket on right side of the transceiver, or
near it using two screws supplied. When mounting in an automo-
bile, place the bracket under the dash so the microphone is readily
accessible.
19.ULTRA.MANUAL.qx 9/15/97 4:09 PM Page 9