![background image](http://html.mh-extra.com/html/cobra/19-ultra-ii/19-ultra-ii_how-to-use-manual_2631053015.webp)
Operation (Cont.)
Operating Procedure to Receive
1.
Be sure that the power, antenna and microphone are properly con-
nected before proceeding further. The CB/PA switch should be in
the CB mode. The Channel 9/NOR Switch should be in the NOR
mode.
2.
Turn the radio ON by rotating the VOLUME CONTROL clockwise.
3.
Rotate SQUELCH CONTROL counterclockwise until incoming sig-
nal is heard.
4.
Turn the CHANNEL SELECTOR KNOB to select the desired oper-
ating channel.
5.
Set the VOLUME CONTROL to a comfortable listening level.
Listen to the background noise from the speaker. Turn the SQUELCH
CONTROL slowly clockwise until the noise JUST disappears (no signal
should be present). Leave the control at this setting. The squelch is now
properly adjusted. The receiver will remain quiet until a signal is actu-
ally received. Do not advance the control too far, or some of the weak-
er signals will not be heard.
Operating Procedure to Transmit
1.
Select the desired channel.
2.
Press-to-Talk Switch.
The receiver and transmitter are controlled by
the press-to-talk switch on the microphone. Press the switch and the
transmitter is activated; release switch to receive. When transmit-
ting, (on a clear channel), hold the microphone two inches from the
mouth and speak in a clearly normal voice.
Be sure the antenna is properly connected to the radio before
transmitting. Prolonged transmitting without an antenna, or a
poorly matched antenna, could cause damage to the transmitter.
Operating Procedure for Public Address
1.
Connect a PA speaker to the PA jack provided on the rear panel.
2.
Set the CB/PA switch to the PA position.
3.
Depress the push-to-talk switch on the microphone and speak in a
normal voice.
4.
Adjust the volume of the PA speaker using the Volume control on
the front panel.
11
19.ULTRA.MANUAL.qx 9/15/97 4:09 PM Page 15