3-6
Chapter 3: Assembly & start up
98-143492-B
Start up with auto-acquisition
Figure 3-8: Tx, Rx RF and BUC cables
13.Connect the AC Power Adaptor to the electronics enclosure.
Figure 3-9: AC power connection
14.Use the four RJ-45 ports for making IP-data connections; there are two separate
functions accessible using these ports:
LAN1 (leftmost) for access to the web interface (setup and troubleshooting)
LAN2 to LAN4 for Internet use etc.
Note
The three standard LAN ports (LAN2 to LAN4) are for Internet and other user data
traffic. The web interface can only be accessed via LAN1. Wi-fi connection must
be configured, see
To configure the LAN network
on page 4-6 and
WLAN settings
on page 4-9.
3.3
Start up with auto-acquisition
The system is set to automatically point and acquire a connection.
WARNING!
Be aware of pinch points while the antenna is being
positioned, deployed or stowed.
To start up the antenna, do the following:
1. Press the On/Off button.
