Cobalt_OM_preprint_shell.fm Page 2 Wednesday, March 1, 2006 5:39 AM
3
-
24
296 Owner’s Manual
COBALT
296
BOWRIDER
S
ECTION
3
Helm Fault Alarm
Appearance -
When the Helm Fault Alarm is
received, the LCD display shows “
H F
” flashing.
2. STEREO REMOTE CONTROL (standard on
dash, transom mount – optional) -
This panel
provides remote control of the stereo system from
the helm.
3. SWITCH PANEL (Port)
BILGE PUMP 1 and 2 -
These switches manually
control both bilge pumps.
BILGE BLOWER -
This switch activates the engine
compartment ventilation blower to remove
explosive fumes from the area. The blower must be
operated for a minimum of four minutes each time
before starting the engine. In addition, the blower
should be operated continuously when at idle or
running at slow speeds. The LED will illuminate if
the switch is on.
HORN -
This switch activates the horn. Press the
switch to activate.
4. IGNITION SWITCHES -
There are two ignition
switches, one each for the port and starboard
engines. The switches start the engines and supply
accessory power when turned to the left.
5. TILT STEERING RELEASE LEVER -
This lever
adjusts the steering wheel angle to a comfortable
position when the boat is not moving.
6. SWITCH PANEL (Starboard)
INTERIOR LIGHTS -
This switch provides
illumination within the cockpit area.
STORAGE and ENGINE COMPARTMENT
LIGHTS -
This switch provides illumination within
the storage areas and engine compartment.
DOCKING LIGHTS (Optional) -
This switch
operates the docking lights.
Docking lights are to be used for docking only. It is
illegal to use your docking lights while cruising.
PLATFORM LIGHTS (Optional) -
This switch
provides illumination within the platform area.
CAPTAIN’S CALL (Optional) -
This switch
determines the routing of the engine exhaust. In the
ON position, engine exhaust is routed through the
thru-hull pipes. This position produces the most
engine power, but is not acceptable near shore or
on inland lakes and rivers.
In the OFF position, engine exhaust is routed
through the hub of the propeller. This position
releases the exhaust underwater, providing a
quieter engine sound.
Be sure to check local regulations regarding noise
restrictions before operating this system.
WINDSHIELD WIPER (Optional) -
This switch
controls the wiper.
NAV. LIGHTS -
NAV/ANC “Lights” - The NAV/ANC
is a three-position switch which activates the
navigational (running) lights and the anchor light.
After installing the light, press the switch toward the
“NAV.” Press the switch toward the “ANC” and the
anchoring/mooring light (360° white) will illuminate.
A
WARNING
Avoid injury, death or explosion.
• Check engine compartment for
gasoline or vapors.
• Operate blower for four minutes.
• Verify blower operation.
• Run blower below cruising speed.
CAUTION
Avoid damage to the exhaust system.
DO NOT switch the routing of the
exhaust above 3,000 RPM.
NOTICE: Operate the boat
between sunset and sunrise
using your navigational lights.
Navigational lights are legally
required to indicate direction
and right-of-way at night.
Summary of Contents for 296 BOWRIDER
