Cobalt Digital Inc 220S, Owner'S Manual

Page: 95 / 134

220S Owner’s Manual 3
-
35
O
PERATING
I
NFORMATION
BIMINI TOP - OPTIONAL
1. Remove the stainless adjustable arms from the
storage area.
2. Unfold the top and install the stainless
adjustable arms (tensioners) into the
quick-disconnect fittings on the deck, forward of
the windshield. Secure the forward arms to the
forward cross members with the pins.
3. Tighten the bimini by twisting the tensioners.
Do not trailer with the bimini top up. Store and
trailer the bimini top in the stowed position, in its
canvas boot.
ECLIPSE ARCH W/BIMINI
1. Fold aft bimini bow toward the back of the boat.
2. Remove canvas boot.
3. Unfold canvas and deploy over the top of the
arch, and put the hole in the canvas over the
anchor light on top.
4. Move forward bimini bow to top quick release
position, and attach the short bimini poles to the
forward bow and quick release.
5. Unzip forward bow support pocket on the
canvas and put over forward bimini bow and
rezip canvas.
6. Pull the aft end of bimini down tight using
adjustable poles to hold tight.
ELECTRIC ECLIPSE ARCH
WITH BIMINI
1. To raise and lower, turn on the master switch in
the helm area, and raise and lower with the
switch located in the aft walk-thru area.
2. Fold aft bimini bow toward the back of the boat.
3. Remove canvas boot.
4. Unfold canvas and deploy over the top of the
arch, and put the hole in the canvas over the
anchor light on top.
5. Move forward bimini bow to top quick release
position, and attach the short bimini poles to the
forward bow and quick release.
6. Unzip forward bow support pocket on the
canvas and put over forward bimini bow and
rezip canvas.
7. Pull the aft end of bimini down tight using
adjustable poles to hold tight.
NOTICE: Do not operate
equipment that has loose or
missing fasteners. Be sure all
fasteners are installed and
properly tightened before
operating equipment.
NOTICE: Do not operate
equipment that has loose or
missing fasteners. Be sure all
fasteners are installed and
properly tightened before
operating equipment.
NOTICE: Do not operate
equipment that has loose or
missing fasteners. Be sure all
fasteners are installed and
properly tightened before
operating equipment.
A
WARNING
Arches or towers are designed to tow a
wakeboarder. Do not tow other boats,
tubes, parasails, etc. Do not climb, jump
or dive off the tower. Do not sit behind
the tower where you could come in
contact with the rope. Do not allow
loose ropes to hang from the tower. Do
not trailer the boat with boards or skis in
the racks. Before and during each use
make sure all bolts and fasteners are
tight. Make sure you have sufficient
clearance above the tower when it is up.
Watch for bridges, power lines, tree
limbs and other low hanging obstacles.
Failure to follow these instructions can
lead to serious injury or death.