FITTING INSTRUCTIONS
DKB200 RING DOOR KNOCKER
LIT-FI-DKB200
Page 4 of 6
T
01726 871 025
E
W
coastal-group.com
Drill the 2 x 9mm holes
for the M8 fixing bolts,
only drilling halfway
through from the front
of the door.
This is so you don’t
split the timber or
cause breakout on the
paint finish.
Affix washer onto end
of bolt on back of
door and secure
the bolt using the
decorative nut.
Hand tighten and
check the Impact
Plate is square on the
outside of the door.
Then tighten the
decorative nut using a
16mm spanner.
Thread the shorter
fixing bolt into the
Impact Plate, turning it
through 3 turns.
Remove decorative
nut and washer from
the 2 x fixing bolts.
Then on the back of
door drill out the 2
x 3mm holes for the
bolts to 9mm, drilling
the rest of the way
through from the back.
Make sure the
Anti-spin Peg is at the
top and thread the
bolt through the door.
Check the Plate is
square on the door
and push in so the peg
on the back enters the
hole drilled for it on
the face of the door.
Measure the thickness of
your door and cut your bolts
to length as follows:
x
Top fixing bolt length (for
Knocker) =
Thickness of door + 28mm
x
Bottom fixing bolt length
(for Impact Plate) =
Thickness of door + 7mm
File the cut end of the Bolt
to give a slight bevel.
5
7
6
8
