Airfusion Abyss Installation Instructions
12 |
P a g e
This fan is suitable for indoor, alfresco and
coastal areas. This product is IP66 rated
and can be exposed to powerful water jets
from any direction. This rating should be
maintained during installation.
PAIRING REMOTE AND RECEIVER – WHEN 2 OR MORE DC CEILING FANS ARE INSTALLED IN ONE
LOCATION
When two or more ceiling fans are located near each other, you may desire to have the remote/receiver for
each fan paired so that the operation of one fan does not affect the operation of the other fans.
NOTE:
Ensure that you have installed a single-pole disconnection switch in the fixed wiring for each fan.
NOTE:
Ensure power to the Receiver is
ON
before pairing the remote with the receiver.
Remote / Receiver pairing for ceiling fan 1:
•
Turn OFF the mains supply to the receivers of both ceiling fans 1 and 2.
•
Install the batteries into the remote. Please make sure the polarity of the battery is correct.
•
Turn ON the power to receiver 1. Keep the power OFF to receiver 2. (Each ceiling fan must have its own
isolation switch so that only the ceiling fan that needs to be paired with the transmitter will be ON).
•
Press and hold the “Forward/Reverse” button of
transmitter 1
for 10 seconds within 30 seconds of
switching the power ON to the receiver of ceiling fan 1.
•
There will be a notification ‘beep’ sound from the receiver to indicate that the pairing process is successful.
•
Turn ON and change the speed of the ceiling fan 1 by the transmitter to check the operation and
successful pairing.
Remote / Receiver paring for Ceiling fan 2:
•
Turn OFF the mains supply to the receivers of both ceiling fans 1 and 2.
•
Install the batteries into the remote. Please make sure the polarity of the battery is correct.
•
Turn ON the power to receiver 2. Keep the power OFF to receiver 1. (Each ceiling fan must have its own
isolation switch so that only the ceiling fan that needs to be paired with the transmitter will be ON).
•
Press and hold the “Forward/Reverse” button of
transmitter 2
for 10 seconds within 30 seconds of
switching the power ON to the receiver of ceiling fan 2.
•
There will be a notification ‘beep’ sound from the receiver to indicate that the pairing process is successful.
•
Turn ON and change the speed of ceiling fan 2 by the transmitter to check the operation and successful
pairing.
