Coast Spas Classic Series, Owner'S Manual

Page: 23 / 32

23
Unlocking
The same steps are used to Lock and Unlock. To lock ei-
ther Settings or Panel first select Settings (if it says
“Unlocked”) or Panel (if it says “Unlocked”), than press the
word “Lock“ for at least 5 seconds. To unlock either Set-
tings or Panel first select Settings (if it says “Locked”) or
Panel (if it says “Locked”), than press the word “Lock“ for at
least 5 seconds.
201912131217
Luxury Topside Quick Reference Card
the upper right corner of the display. These ranges can be used for
various reasons, with a common use being a “ready to use” setting
vs. a “vacation” setting. Each range maintains its own set tempera-
ture as programmed by the user. This way, when a range is cho-
sen, the spa will heat to the set temperature associated with that
range.

High Range can be set between 80°F and 104°F.

Low Range can be set between 50°F and 99°F.
Heat Mode – Ready vs. Rest
In order for the spa to heat, a pump needs to circulate water
through the heater. The pump that performs this function is known
as the “heater pump.” The heater pump can be either a 2-speed
pump (Pump 1) or a circulation pump. If the heater pump is a 2-
Speed Pump 1, Ready Mode will circulate water every 1/2 hour,
using Pump 1 Low, in order to maintain a constant water tempera-
ture, heat as needed, and refresh the temperature display. This is
known as “polling.” Rest Mode will only allow heating during pro-
grammed filter cycles. Since polling does not occur, the tempera-
ture display may not show a current temperature until the heater
pump has been running for a minute or two. When the heater pump
has come on automatically (for example for heating) you can switch
between low speed and high speed but you cannot turn the heater
pump off.
Restricting Operation
The control can be restricted to prevent unwanted use or tempera-
ture adjustments. Locking the Panel prevents the controller from
being used, but all automatic functions are still active. Locking the
Settings allows Jets and other features to be used, but the Set
Temperature and other programmed settings cannot be adjusted.
Settings Lock allows access to a reduced selection of menu items.
These include Filter Cycles, Invert, Information and Fault Log. They
can be seen, but not changed or edited.
The Lock option can be accessed from the “
Settings ” menu.